Many customers will print out the Cut List by Panel report. This allows the assemblers to see the materials based on each panel.
Users can add additional information for a particular component by entering it in the Notes field located next to each component on the design screens (small square) OR can enter a general notes for the order on the Container -> Overview tab which will appear at the bottom of the report.
Question from customer carried forward from previous help desk:
In my shop the assemblers have trouble reading the cut sheets we provide to the sawyers. I print out the diagram which tells them how the pieces "goes together", even though its not to scale. This works fine but they take too much time going down the cut sheet to figure out which piece goes on which panel.
Whats a suggestion?